3.Modification of Cable.

First, release the clamped point of cable.


Then, remove all skin of cable. Use some small knif cut the skin crefully and remove it.
DO NOT pull the cable.

Loose internal mesh part.


Insert TWO lead wire into the mesh part.


Thease leads will be soldered to PIN#21 and PIN#22 of DAC.


Ok, Go ahead solder them to PIN#21 and PIN#22. PIN#21 is H sync. PIN#22 is V Sync.
Remeber the color of each cable and pin.


After soldering. Put mesh part back to original posotion.

Put vinyl tube into cable protector.


Next, put cable into the tube. If you feel hard to that, remove string and paper like thing which exists inside of mesh part.

Then, position the tube & cable followings. and thigh up them back like original.


All of thease steps are done. close "CAN" part and connector cover.

[Next]
[Back]