4.Attach VGA Connector.

You can find How-To of VGA connector attachement. So, I do not describe this steps in detail.

Prepare cable of mesh part. Bend it back toward to tube and cut it.
Attach 2 wire for GND to mesh part.


Inside of the cable, you will see three silver leads. Thease are Coaxial cables.
Remove silver part and separete into GND and Signal.


Put some isolation tube to outer part of coaxial cables.

Internal part of coaxial cable indicates its"color". Red will go to R.

Then solder this part to VGA connector. VGA's pins are follows.Do you remeber which wire is H (or V)?

1-----R
2-----G
3-----B
4-----N/C
5-----N/C
6-----R-GND
7-----G-GND
8-----B-GNC
9-----N/C
10----GND
11----GND
12----N/C
13----H Sync
14----V Sync
15----N/C




[Next]
[Back]